AR57 Extractor

Discuss the FN lineup of tactical rifles; the FS2000, SCAR, and the venerable FAL.
Post Reply
Aslap
Junior Member
Posts: 1
Joined: 01 Jan 2017, 09:29

AR57 Extractor

Post by Aslap » 01 Jan 2017, 09:38

I am replacing the extractor in my AR57 upper. This is an old one that I bought probably 8 years ago or so. I assume it's a Gen 1. I also assume that some changes were made to the extractor in the Gen 2 version. I received the spare parts and there is no way that the extractor and spring can be installed in my bolt. The hole on my bolt allows for the little tab on the extractor to fit in but the spring does not fit in the hole and the tab at the rear of the extractor does not fit inside the spring.

I'm looking for confirmation as to the Gen 1/Gen 2 changes and also just how the extractor is supposed to fit into the bolt. I'm figuring that the spring goes in the hole; the tab on the back of the extractor fits into the spring; and the roll pin holds it together. Does this sound right?

Thanks

Tony

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests